Bigaimaj Kitchen Countertop Self-Adhesive Foil Coating Marble Pattern

You can perform the countertop coating by following these steps. Remove all accessories on the countertop and stove before proceeding with the kitchen countertop coating process with countertop adhesive foil. If there is dirt or food residue on your countertop, wipe it clean using appropriate cleaning products. Then dry thoroughly so that there is no wetness left, making the floor suitable for coating. Take the measurement of the counter using a tape measure. The most important point you should pay attention to when taking measurements is; account for the counter bottoms too. Make marks on the foil with a pencil according to the size you bought. You can prevent leaving a mark on the color or pattern by doing the marking on the reverse side of the foil. Carefully cut using scissors from the places you marked. You can prioritize covering baseboards so your hand gets used to it. In this way, you will have practiced for the countertop, which has a larger area. Then start placing the foil on the counter, leaving 5 to 10 cm from the sticky part. Be as slow and careful as you can when doing this process. On one hand, open the foil and stick it, on the other hand, push the parts you have stuck outwards with the help of a silicone spatula. This is a must-do process to ensure that there are no air bubbles and to achieve a smooth surfaceContinue this process until the countertop is completely covered. If you want, you can cut the foil into different parts of the counter and make a coating piece by piece. However, the most ideal method is to cover the counter by using the foil as a whole. After the coating process is completed in a whole way, you can cut parts such as the stove and sink with a utility knife. Cut off the excess on the edge with a utility knife and make final touches. If small air bubbles have formed on the surface despite your care, you can pop them with the help of a needle or toothpick. Apply the cold silicone to the corners, around the sink and stove in the final stage. Used longer this way.

130 micros

It is water resistant and because it is laminated, chemicals like bleach and oil remover do not lighten its color. In the end, the coated pot should not be placed directly from the stove, a trivet should be used, and no cuts should be made on the pole. It must be used carefully, as on granite and wooden countertops.

When you buy 3 pieces, a whole piece of 70cmx300cm is sent to you, you can use it by cutting it.

yes it is 70cm wide