Arduino 12v/60 Led Outdoor Ip65 White LED Strip 5 Meters

Hello sir, yes it is available.

Hello sir, it is not suitable for contact with water.

Hello sir, This strip 5 meters long led requires about 5A current. You can use it with a 12V 5A or slightly higher current capable adapter

Hello sir, yes this strip LED can be cut to use. The cutting points on 12V strip LEDs are generally where the scissor mark / copper pads are on the strip (usually every 3 LEDs). If you cut from the outside of those marks, that section may not work. Things to consider for smooth operation: Power Supply: Always use a 12V DC adapter (AC/transformer output or different voltage is not suitable). Polarity: +12V and GND (-) should not be connected in reverse. Adapter power: The adapter should be chosen according to the current drawn by the 5 meter LED strip. In practice, at least 12V 2A, 12V 3A adapter is recommended for healthier use. Outdoor (IP65): This product is suitable for outdoor use; however, the cut end loses its IP65 rating after cutting. It is necessary to isolate/seal the cut end with silicone. With the correct adapter and correct connection, it works normally when you receive the product. If you want, write down how many amperes the 12V adapter you will use is, and I will tell you clearly whether it is suitable.

Hello sir, it is 2-3cm.