Moonstar Protective Steel Glove 5 Finger Large / Bmglv-01L

User manual

Special note on the use of protective gloves

The use of this protective glove is limited to manual knife handling in the food, plastics, leather, paper, and textile industries.

Safety instructions:

The instructions for use must be read and observed before using the glove.

If you have any questions, please contact your employer or manufacturer.

The glove must be checked before each working day for use. in the case of defects such as deformed, defective or missing rings and/or sealing tape or snap buckle, the glove must be presented to the employer and replaced.

The glove must not be modified or re-adapted by the user and must be used in the design provided.

The glove is electro-conductive and should not be worn near exposed or unprotected electrical lines.

Gloves should not be worn while operating motorized vehicles or machinery with moving parts.

The glove knife should be on the hand holding the product, not on the hand that carries it.

The user is responsible for verifying the suitability of the product for its intended use. depending on the specific task, a sleeve extension glove is optionally available to prevent cuts to the upper or lower arms, or knife injuries.

Not suitable for transporting hazardous materials.

Selection of gloves:

Before using the glove, the corresponding hand size should be determined.the glove should fit well on the fingers and palms of the hands.in connection with the textile or plastic glove-bottom, the correct connection should also be checked and make sure that the fingers can be easily moved.

The size of the gloves is marked by colors (see the color of the sealing tape) and also by the letters (see the table) on the identity tag located on the glove:

 

Brown	Yeşil	Beyaz	Red	Mavi	Orange
Xxs	Xs	S	M	L	Xl

 

Gloves are available with and without a cuff extension. the appropriate gloves should be selected based on the specific job requirements and required level of safety.

Secure closure of the glove is ensured by correct closure of the sealing tape and snap buckle.overlapping ends of sealing tapes, if they are longer than 25 mm, should be shortened.

Maintenance/cleaning:

To ensure the ideal protective effect, the gloves must be kept in perfect condition.under normal use, the gloves are subject to natural wear and tear.

If there are visible signs of wear, such as deformed, defective or missing rings, worn sealing strips and/or snap buckles, the glove must not be used and must be replaced.

Before or after cleaning, avoid striking or impacting the glove against a hard surface.

Gloves should be cleaned and disinfected at least once a day using hot water or a cleaning agent approved for the food industry. we also recommend scrubbing the gloves to remove any residue (e.g., meat residue, etc.).

Gloves can also be cleaned in suitable cleaning machines.in order to achieve the best possible cleaning effect, gloves are hung in suitable cleaning boxes.

Regarding cleaning, the user must comply with the employer's applicable cleaning plans to ensure professional hygiene.

Warranty / liability

All protective glove production products undergo quality control of materials and assembled products during production and before use.defective goods must be reported to the manufacturer in accordance with legal regulations.the manufacturer rejects any claim of responsibility and liability if the products were not repaired and serviced in internal workshops.if the products are not used correctly and properly, no warranty or liability claim is available.