Free shipping
Generic 433 Mhz Superheterodyne RF Receiver And Transmitter Module For Arduino Uno Wireless Module Diy Kit 433Mhz Remote Control
No reviews yet.
56
AED
(incl. VAT)
Delivery address
Free shipping
Local delivery
Estimated delivery: 22 - 24 October
Select your address, find out the delivery date!
Trendyol's commitments
Easy and free return in 15 days.
Payment methods
Highlighted features:
Generic 433 Mhz Superheterodyne RF Receiver And Transmitter Module For Arduino Uno Wireless Module Diy Kit 433Mhz Remote Control features
Other Features
High sensitivity, Low-power performance, High dynamic range, Highly integrated chip, Built-in LNA, Good selectivity, Spurious radiation suppression, Good local oscillator radiation suppression, Non-interfering multiple modules, Multiple transmission rates
Instructions for Use/Warnings
External antenna: 32cm single core wire, wound into a spiral. Mains input voltage range: 3.0V–5V. Pinout: 1. ANT: Antenna pin, 2. GND: Power ground pin, 3. VIN (VDD): Power input pin, 4. DO (DATA): Data output pin, 5. DO (DATA): Data output pin, 6. GND: Power ground pin.
Blue PCB Electronics
7.8
Seller information
Shoppers also viewed
Set of 4 Lined Notebooks 13 X 20 Cm 56 Sheets Cardboard Cover Spiral Notebook Notebook Line Series
Generic 433 Mhz Superheterodyne RF Receiver And Transmitter Module For Arduino Uno Wireless Module Diy Kit 433Mhz Remote Control reviews
No reviews yet.
Product details
Product description
Description WL101-341 superheterodyne wireless receiver module is receiving UHF ASK demodulators supporting ASK and OOK modulation.
The receiver module has high sensitivity (-110 dBm).
Low-power performance, along with a high dynamic range (greater than 60 dB).
The module uses a highly integrated chip, a built-in front-end low-noise amplifier, mixers, filters, frequency synthesizer circuit, etc.
, to maximize signal optimization.
Low power consumption Good selectivity and spurious radiation suppression.
Good local oscillator radiation suppression, multiple receiver modules to work with (i.
e.
, more than one income) that will not interfere with each other, used together without affecting the receiving distance.
Multiple transmission rates: the general module for 2 kHz, up to 10 kHz.
Specifications: Model: WL101-341 Material: Plastic + Metal Color: shown as pictures Size: 30.25×8.5×1mm Operating frequency: 433.92 MHz Bandwidth: about ± 150 kHz
Mains input voltage range: 3.0V–5V
Working current: Type: 5.0mA (Requirement: VDD=5 volts)
Type: 6.0 mA (Requirement: VDD=3V) Quiescent Current: 1uA Temperature range: -40°C to 85°C External antenna: 32cm single core wire, wound into a spiral Pinout 1. ANT: Antenna pin2. GND: Power ground pin3. VIN (VDD): Power input pin4. DO (DATA): Data output pin5. DO (DATA): Data output pin6. GND: Power ground pin
Additional info
- Sold by .
- A maximum of 5 units of this product can be ordered. Trendyol reserves the right to cancel orders over 5 units.
- Barcode No: 2900000004207
Generic 433 Mhz Superheterodyne RF Receiver And Transmitter Module For Arduino Uno Wireless Module Diy Kit 433Mhz Remote Control features
Other Features
High sensitivity, Low-power performance, High dynamic range, Highly integrated chip, Built-in LNA, Good selectivity, Spurious radiation suppression, Good local oscillator radiation suppression, Non-interfering multiple modules, Multiple transmission rates
Instructions for Use/Warnings
External antenna: 32cm single core wire, wound into a spiral. Mains input voltage range: 3.0V–5V. Pinout: 1. ANT: Antenna pin, 2. GND: Power ground pin, 3. VIN (VDD): Power input pin, 4. DO (DATA): Data output pin, 5. DO (DATA): Data output pin, 6. GND: Power ground pin.
Safety information
Product safety information