Generic 2D10B Ky-028 Digital Temperature Thermistor Thermal Sensor Module

Product description

Description The KY-028 Digital Temperature Sensor measures temperature changes based on thermistor resistance.

This module has both digital and analog outputs, there’s a potentiometer to adjust the detection threshold on the digital interface.

Compatible with Arduino, Raspberry Pi, ESP32, and other microcontrollers.

SPECIFICATIONS This module consists of an NTC thermistor, an LM393 dual differential comparator, a 3296W trimmer potentiometer, 6 resistors, 2 LEDs, and 4 male header pins.

The module features analog and digital outputs.

Operating Voltage 3.3V ~ 5.5V Temperature Measurement Range 55°C to 125°C [-67°F to 257°F] Measurement Accuracy ±0.5°C Board Dimensions 15mm x 36mm [0.6in x 1.4in] CONNECTION DIAGRAM Connect the board’s analog output (A0) to pin A0 on the Arduino and the digital output (D0) to pin 3. Connect the power line (+) and ground (G) to 5V and GND respectively.

Y-028 Arduino A0 Pin A0 G GND + +5V D0 Pin 2 CODE When the temperature threshold is reached, the digital interface will send a HIGH signal turning on the LED on the Arduino (pin 13).

Turn the potentiometer clockwise to increase the detection threshold and counter-clockwise to decrease it.

The analog interface returns a numeric value that depends on the temperature and the potentiometer’s position.

Since the analog output pin is directly connected to the potentiometer it isn’t possible to use the Steinhart-Hart equation to calculate the temperature as we did with the KY-013, we can only use this value to measure relative changes in temperature.

int led = 13

// define the LED pin int digitalPin = 2

// KY-028 digital interface int analogPin = A0

// KY-028 analog interface int digitalVal

// digital readings int analogVal

//analog readings void setup() { pinMode(led, OUTPUT)

pinMode(digitalPin, INPUT)

//pinMode(analogPin, OUTPUT)

Serial.

begin(9600)

} void loop() { // Read the digital interface digitalVal = digitalRead(digitalPin)

if(digitalVal == HIGH) // if temperature threshold reached { digitalWrite(led, HIGH)

// turn ON Arduino's LED } else { digitalWrite(led, LOW)

// turn OFF Arduino's LED } // Read the analog interface analogVal = analogRead(analogPin)

Serial.

println(analogVal)

// print analog value to serial delay(100)

Additional info

• Sold by
  Blue PCB Electronics
  .
• A maximum of 5 units of this product can be ordered. Trendyol reserves the right to cancel orders over 5 units.
• Barcode No: 2900000004863