Free shipping
Delivery address
Free shipping
Local delivery
Estimated delivery: 21 - 23 October
Select your address, find out the delivery date!
Trendyol's commitments
Easy and free return in 15 days.
Payment methods
Highlighted features:
Generic 1D26 HC-SR04 Ultrasonic Module Distance Sensor features
Other Features
Non-contact measurement, suitable for robot obstacle avoidance and path-finding applications, easy to use, low cost
Instructions for Use/Warnings
To function, lift the Trig pin while keeping the Echo pin down for approximately 10 seconds. Set the trigger pin HIGH for 10µs to initiate an ultrasonic burst. For wiring, connect VCC to Arduino 5V, GND to Arduino GND, Trig to Arduino Digital Pin 9, and Echo to Arduino Digital Pin 10. Install the NewPing library in the Arduino IDE (Sketch > Include Libraries > Manage Libraries, search 'newping', then install). Use the provided example code, upload it to Arduino, and open the serial monitor (9600 bps) to view distance measurements. The Echo pin goes HIGH when the burst is transmitted and LOW when an echo is received; the pulse width indicates distance. A 38ms echo signal timeout indicates no obstruction within range.
Blue PCB Electronics
7.8
Seller information
Generic 1D26 HC-SR04 Ultrasonic Module Distance Sensor reviews
No reviews yet.
Product details
Additional info
- Sold by .
- A maximum of 5 units of this product can be ordered. Trendyol reserves the right to cancel orders over 5 units.
- Barcode No: 2900000009073
Generic 1D26 HC-SR04 Ultrasonic Module Distance Sensor features
Other Features
Non-contact measurement, suitable for robot obstacle avoidance and path-finding applications, easy to use, low cost
Instructions for Use/Warnings
To function, lift the Trig pin while keeping the Echo pin down for approximately 10 seconds. Set the trigger pin HIGH for 10µs to initiate an ultrasonic burst. For wiring, connect VCC to Arduino 5V, GND to Arduino GND, Trig to Arduino Digital Pin 9, and Echo to Arduino Digital Pin 10. Install the NewPing library in the Arduino IDE (Sketch > Include Libraries > Manage Libraries, search 'newping', then install). Use the provided example code, upload it to Arduino, and open the serial monitor (9600 bps) to view distance measurements. The Echo pin goes HIGH when the burst is transmitted and LOW when an echo is received; the pulse width indicates distance. A 38ms echo signal timeout indicates no obstruction within range.
Safety information
Product safety information